Page 111 - allcolor_Klebebandkatalog

Informations and Directions
for use of Tapes and Foils

1. Surface 7. Warranty
- The surface should be dry, free from fat, oil and dust. If necessary, - Although given to the best of your knowledge, no warranty is given
clean the surface well by using a clean rag and an appropriate on any information or advise, as varying working conditions are out
detergent. of our control or assessment. We refuse any liability whatsoever for
- A porous surface, such as plaster or colour that is crumbling off the tapes supplied by us. We recommend preliminary tests of the
needs to be pretreated in an appropriate manner. tapes. We put test samples at our disposal and give you technical
advise and assistance free of charge, to help you choose
2. Temperature the appropriate tape for your application. All our tapes are
- Foils and tapes should be applied at average room temperature manufactured under permanent quality control. All technical data
( not less than the minimum temperature recommended). are according to the information from the suppliers. Any liabilities
given are therefore just accountable for the immaculate condition of
3. Applying the Tape the products itself.
- Do not touch adhesive side of the tape. After the tape has been
applied, press it to the surface again. When using double-sided 8. Caution by sticking of wood
tapes, remove the protective paper carefully. - Wood is a difficult surface. When you remove the tape by jerks,
- Take the surface quality into consideration, on a rough surface a the fibre will stand up. Please make tests and remove the tape
tape usually has an inferior adhesive strength. slowly, not by jerks.
- Test the adhesion on the tape before applying it to the surface
of your choice. Leave the tape on the test surface for quite a 9. Caution by sticking on plastic
while (over night, if possible). The tape should leave no residues If you stick tape on plastic plasticizer hikes can be produced.
when being removed by jerks after a while. Adhesions tests This can lead to adhesive residue and/or discoloration of the
should be always made on inconspicuous places. plastic. Please do in advance adhesion tests in the same length of
the application.
4. Removing the Tape
- Remove the tape slowly, not by jerks. 10. Caution by sticking on soft and porous surfaces
- Please observe minimum temperatures and recommended time If you stick tape on soft and porous surfaces like softwood,
of longest possible adhesion. new painting or plaster the surface con be damaged.
- Do not leave the tape to stick on the surface longer than necessary.
- When using the tape outdoors, please take the weather into 11. Caution by sticking on glazes and hydrous paint
consideration. Caution by sticking on glazes and hydrous paint, the plasticizer
of the glue can damaged the surface.
5. Storage
- Tapes should be stored in original packing not longer than six 12. Caution by sticking on
months at a room temperature and recommended temperature aluminium, copper, zinc and other metal
(20 °C) and a relative atmospheric humidity of 60 %. Because of chemical reactions it can lead to discoloration
- Once the original packing has been removed, tapes should be and/or glue residue.
stored dry and clean.
- Protect tapes against sunlight und UV-light. 13. Caution by sticking on natural stone and marble
We advise in principle against sticking on natural stone and
6. Special directions for use marble, because of it can lead to permanent discoloration,
- Some of our qualities require special instructions for use. If you shading and glue residue.
should have questions or difficulties, please contact for
detailed advise. If necessary, we visit the site of application, to find
the best possible solution for your application problem.

109